Welding needed for the John Deere H spindles

Here is a part I repaired for a fellow a while back.  The tractor had continued to be used after the wheel bearings had failed and the front spindles were severely damaged.  The repair involved welding the damaged areas to fill in the worn away material, then machining away the weld to restore the bearing surfaces to their original sizes.  I was not able to remove the 3 foot long steering shaft from the spindle assembly so it made turning them back down a difficult task.




About maxxind

After working in the research and development fields for 20 years doing electronics and machining work, I'm now out on my own trying to make a go of it.
This entry was posted in Uncategorized. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s